Estes Advanced Target Drone, Kit #1913, Build, Part 8, Lug Position & Shroud Fit

The instructions show the the front of the launch lug even with the leading edge of the wing fin. This would put the lug beyond the back edge of the intake.

I decided to glue the lug a bit forward so it would be hidden under the intake shroud. 

A dry fit shows the lug better hidden under the intake.

You'll have more control if you glue one side of the intake at a time.

Look at the top inside edge of the intake and you can see the pencil marks I drew to show where the glue will go.

It doesn't take much glue to set the intake edges. Draw a bead of glue, smooth and remove excess with a fingertip.

TIP: Notice in the above picture, the printing is on the inside. When you can, keep the printing out of sight. Some printing can show through color coats.

Here's a good fit of the intake against the root edge of the top rudder fin. 

I haven't glued the slot joint yet.