On the left is the nose cone tip decal. It is an arc to fit the nose cone tip taper.
On the right side was my first attempt. I painted the silver too low. The decal wouldn't meet and didn't cover up the silver/white mask line.
The silver had to be sanded down and the mask repeated in the right location.
Wrap the arc decal around the nose cone tip before painting to find the correct height.
The instructions don't tell you how far down the silver mask goes.
I found the right depth to be 15/16".
This should set the red arc decal width right over the mask line.
I cut an arc out of marked Scotch tape. This could take a few tries to get the line smooth.
Thanks for that "heads-up" on that nose mask! It is definitely a detail that is easily missed, and most builders are apt to realize the problem in the same manner as you did.
ReplyDelete