Estes Antar #7310 Build, Part 13, Wing Mask

Here's the first draw of the wing mask.

After printing the PDF, it is cut down the zig-zag mask line.

One half of the full size mask template is set on the fin, matching up the ends.

The picture on the right shows a very faint pencil line for the masking tape placement. If you trace a pencil line on balsa, go light! You don't want to scar the soft wood.

I use Scotch tape for masking.

To see the tape edge, I mark it with a wide tip permanent marker. 

After the black ink dries, wipe over the line with a paper towel to remove any extra that might be transferred onto the model surface.

The other half of the template is used as a cutting guide for the zig-zag color separation line. 

Here's the mask for the green paint. The open white areas of the body will need to be covered before spraying the green.

Notice the many smaller pieces at the upper tips to fit the rounded leading edges.