Estes Shark #1111, Build, Part 8, Engine Mount & Fin Gluing

Set the engine mount and Kevlar line alongside the lower, longer tube.

The BT-20 engine tube is even with the bottom of the BT-50 main body.

This gives you an idea how long the Kevlar line should be, a little shorter than the top of the BT-50.

Tie a overhand loop knot (shown on the right) for the elastic shock cord attachment.

I used epoxy to glue the mount in, allowing me some positioning time.

Here's the BT-50 tube with the filler/primer scraped off where the fins will be glued. The scraping is a little shorter than the length of the leading edge.

The low fins are glued even with the end of the body tube.

On the forward fins and thrusters, I used a wrap of masking tape as an low alignment line at the corner of the trailing edges.