Monday, November 9, 2026

Estes Strikefighter, Kit #2015, Build, Part 31, Canopy Frame Trim

The instructions say to paint the "raised areas" of the canopy white. My home made canopy doesn't have a metal frame. I still wanted some white trim.

Instead of trying to paint even, straight lines, I cheat.
Some clear decal paper was spray painted gloss white. You could use white decal paper without the paint but the white won't be as opaque.



Some thin strips were cut.

The verticals were transferred first. 
It's a bit tricky. Make them long enough so the ends will be covered by the next piece.
The second strip goes over the top, covering the first two top ends.

I probably won't add trim to the curves sides. It would be difficult to get the decal strip to curve around the base.

A perfect clone? Nope! Clones ends up close.

5 comments:

  1. The white trim look great. I've had problems with painting over clear and white decal film. Sometimes the paint flicks off. Any suggestions?

    ReplyDelete
    Replies
    1. Hi Bill,
      I haven't had any paint flaking off a decal sheet. It might depend on who made the paper and the brand of paint you are using.

      Delete
  2. Your "cheat" (using strips of decal rather than painting the canopy frame) is somewhat common in model aeroplane modelling. It is especially handy when dealing with "greenhouse" or "birdcage" type canopy (type of canopy where it consists of numerous small transparent panels held in a metal frame -- some examples from WWII era include aircraft such as the North American T-6 Texan, Junkers Ju 87 Stuka, and Mitsubishi A6M Zero).

    ReplyDelete
  3. Hi Naoto,
    I'm sure this decal/paint trim idea has been used before. I only started using it a few years ago, long after my plastic model building days.

    ReplyDelete
  4. A variation on this idea is often used with balsa-and-tissue model aeroplanes to add frame or border onto the windows - stick the coloured tissue or paper onto the clear plastic windows using dope (type of lacquer used on model aeroplanes).
    If I'm not mistaken, using dope as glue is mentioned on the instructions for the Estes Semi-scale Saturn V kit to glue the clear plastic fins, as well as making the clear slip-on fins for the larger 1:100 scale Saturn V model.

    ReplyDelete