Thursday, November 12, 2026

Estes Strikefighter, Kit #2015, Build, Finished



Whew! This was a challenge.
Thanks go out to SCIGS30. His Rocketry Forum build pics helped with the decal placement. I didn't have a kit face card for reference
The nose cone was beautifully 3D printed by Augendoc.

There are plenty of decals on the upper side of the model.




As with many kits, decals are sparce on the underside.
The original kit had an 18" chute! Probably to keep the overhanging fins from breaking at landing.







The leading and outside fin edge decals were difficult to place. The corner lines should line up, one on top of the other.

6 comments:

  1. This was an incredibly challenging and detailed build. I admire your perseverance and ability to stay on task despite the challenges. Congratulations on a beautiful rocket!

    ReplyDelete
    Replies
    1. Hi Augendoc,
      It turned out to be a bigger challenge than I thought it would be. Thanks again for the nose cones.

      Delete
  2. The build is just awesome. The detail and the decals make the rocket a show piece.

    ReplyDelete
    Replies
    1. Hi Bill,
      The 1989 Estes design team gets all the credit for this one!

      Delete