The large black decal butts up against the front of the canopy. Note it overlaps the break between the nose cone shoulder and body tube.
I normally would wait for the decal to dry before cutting the joint, but I couldn't get the decal to lay flat. I was concerned it as it dried it might be lifted at the joint.
A bit of a white line showed under the cut.
A Sharpie carefully lined the shoulder and body tube edge.
The picture on the right shows no break in the black.



For minor lifting of decal edges, you could apply some thinned white glue at the lifted edges, then gently "massage" that lifted section down.
ReplyDelete