I got a better idea of the length slipping the loose end through the body tube, letting it hang out the back.
1/4" of coupler is cut off and used for the engine block.
Tie the Kevlar onto the engine block.
Mark a length of remaining coupler at 3/4" to use for the engine block placement. Glue the engine block into place.
The small launch lugs are glue in line.
As it was setting up, it slid up, leaving a small gap at the shoulder lip.
I filled the gap with CWF followed with a shot of filler/primer. After sanding it down the gap was pretty much gone.
No comments:
Post a Comment