Aerotech Mega Initiator #89541, Part 13, Prepping More Stickers

Here's the upper body wrap. 

The curves were cut with scissors. Notice I cut a little away from the orange arcs, just playing it safe on the clear border.

Cut the straight lines with a knife and straightedge.

 

In addition to lining up the top edge with the tube end,

you'll need to line up the wrap left side down the tube.

Use your aluminum angle to draw a light pencil line down the tube, as long as the left edge of the wrap.

Before peeling off the backing, do a dry fit.

When the lower arcs were lined up, I noticed one side of the wrap was a bit tall. I went back with a straightedge and cut a long sliver to even up both sides.

Next post we'll attach the roll wrap. It's easier than I thought it would be.