TIP: That inside glue tab can distort the final "round" of the nozzle shroud.
Sometimes you can sand a small flat spot on the ring that fits the raised tab better.
You won't have to sand off much!
After sanding the "flat" spot -
This shows a better fit of the inside glue tab against the 20/50 ring.
The glue fillet was applied at the 20/50 ring / nozzle shroud joint.
When the glue is wet, the shroud will be pliable.
I rolled over the seam where it looked like it was going out of round.
No comments:
Post a Comment