Enerjet by Aerotech Strong Arm Build, Part 18, Waiting For Paint To Dry and Planning Ahead

You may have noticed a slowing of posts - 

That's because I'm building three Strong Arm kits at the same time.

One is a flight version - no seam fills and less attention to details. These are sometimes referred to as: "They'll look good on the pad."

Duplicate builds slow things down, I can't repeat the same build posts three times.

Planning ahead,

You might assume this roll pattern sticker would just roll around the tube -

These will have to be cut apart and placed individually.

But, there is 17/32" space between each vertical bar. 

To make placement easier, I'll print a spacing guide.

It'll be a fin marking guide from payloadbay.com

To go to the marking guide tools: CLICK HERE

Hit TOOLS and then FIN WRAP TOOL.

There are eight bars going around a 2.638" diameter tube.