The rear windows on the nose cone didn't fit into the molded borders.
I had to cut them apart and position them closer together.
The cockpit window decals were a little too wide to fit into the molded lines. I place it as well as I could, there was some overhang.
After the decals dried I was able to trim up the overhang.
There was a overhang tick where the corners of the orange decals met up. Look to the middle left of the orange band.
Here's the decals after trimming.
The front engine pod decal went beyond the root edge and onto the wing.
A very light cut was made with a new razor blade just cutting through the decal, not into the paint.
No comments:
Post a Comment