Model Minutes Leduc 22 Build, Part 12, Nose Weight

Here's the nose weight supplied with the kit. I'll be using a D12 engine so all of it will go inside the upper nose section.

Look close and you will see the bad fit of the small nose cone tip.

Almost all the clay was pressed into the upper section and nose cone. I was able to use the clay to better form the nose cone tip.

The bottom of the upper nose section got a card stock disk glued on.
Notice the three blue dots.

The dots are the dowel (clear canopy) support locations.
You are told to punch holes for the dowel ends. I used the old spinning knife tip method.