Saturday, June 18, 2022

Odd'l Rockets F-18 Hornet Development & Build, Part 4, Engine Mount & Jet Engines



The engine mount is standard with the Kevlar line retained under the top bend of the engine hook.

The engine tube is an Odd'l Rockets heavy wall BT-20H, stronger than a standard BT-20.
A tube marking and cutting template is supplied with the kit. You will be removing a long rectangle piece so the BT-5 tube can overhang the end of the BT-50H main airframe tube.

Wrap and tape the paper template around the BT-5 tube. Punch small holes with a pin down the cut lines. Remove the template and connect the punched dots with a pencil line.


With a new, sharp blade -
Cut the end first.
Then cut the long side lines. You'll find it easier to cut a straight line using a aluminum angle for a knife guide.


Here's what you should end up with.
Notice there is some rough edges.



Careful sanding with a block will clean up and straighten out the cut lines.

No comments:

Post a Comment