Estes USS Enterprise #1275, Part 28, The Recovery Probe

When the face of a centering ring is exposed - 

I like to sand, seal, then re-sand the face.  

This rear ring face was sanded with 220 on a block,

then got a wood glue coat rubbed in,

Then more sanding with 220 and 400 grit.

The long 1/8" dowel is there to reinforce the thin walled BT-20.

The upper picture shows the glue line before the dowel was set down.

My dowel had a slight warp. I let the glue set up a bit before placing the dowel. The half dried glue helped hold the dowel to a straighter line. Fillets are going to be fun!

In the picture, this sealed ring face is facing down, against the long dowel.

The BT-50 parachute tube is slid down and butts up against the outside edge of the dowel. 

Apply a ring of glue inside the BT-50 and slide the tube down until it stops against the top end of the dowel.