Estes Time Warp Build, #7321, Part 2, Paint Plan & Engine Tubes Fill

Planning ahead!

If you want to paint the rocket in the face card colors, paint the build in sections before gluing it all together.

The BT-5 cluster tubes are yellow and would be difficult to paint if glued into the gray BT-55 tube.

That yellow adapter could be painted before gluing into the white BT-50. Same goes for the gray nose cone. Paint them before gluing together and get instant "masks" or color separations. 

_____________________________________________________________________

The lower centering ring is glued 2" down from the tops of the BT-5 motor tubes. I filled the tube seams below that.

The seams were shallow, here you can see the pencil lines where they could be felt.

CWF was used to fill the bulk of the seams and sanded smooth.

The upper 2" (glue area) was masked off and the low end sprayed with filler/primer. Sanding this down filled any remaining seams.