Estes Mini Arcas, #2441, Part 4, Tail Cone Fix - Gotcha!

After forming too many shrouds printed from the scanned kit tail cone,

I thought I'd try the provided kit shroud.

GOTCHA: The kit shroud fit like my scanned cardstock ones did - 

It fits the BT-5 but was small on the BT-20 top end.

So - off to payloadbay.com and their transitions tool.

Four more were printed and cut out.

Notice the picture on the left - 

You can see some very subtle raised areas. With 400 grit, sand and round them down. This removes the high spots and makes a better fit at the base of the BT-20.

Four cardstock tail cones were formed with a clean dowel in the heel of my left hand. Check the last post picture.