Estes Time Warp Build, #7321, Part 15, Upper Decals

The roll pattern decal is shown positioned all the way against the top of the BT-55 tube. This could lead to upper edge peeling.

I'd recommend leaving a little of the clear above the upper edge.

Position the top of the decal a bit below the top of the BT-55 tube. 

The roll pattern has four black vertical boxes. How can you center four boxes over three fins? Well, you really don't. Center one box over the fin opposite the launch lug and let the wrap fall where it may.

I did a tape wrap below the decal final position marked with a pencil line directly above the fin below. This was the fin opposite the launch lug.

This centers one black box over one fin and spaces the other three boxes evenly around the body.

The TIMEWARP 00143 is set down a little to the bottom of the white tube.

TIP: Use your aluminum angle to check the alignment.