The missile launcher heat sinks needed many cuts to free them from the card stock.
The instructions show the first two heat sinks simply glued to the sides of a dowel. These first two heat sinks would end up low and not centered on the dowel. All the remaining pieces would end up even more off center.
I used one of the other heat sinks pieces to raise up the piece I was gluing.
This was repeated on the other side and did put the root edges down the center line of the dowel.
Before gluing any of the heat sinks, be sure they are straight and flat!
On the left is after removing from the sheet, the inset shows it straightened out.
No comments:
Post a Comment