Using white glue, glue the fins on even with the back end of the body tube.
Simply match the fin color to the facing body tube color.
White glue dries clear, don't use yellow glue on the outside surfaces of printed carded models!
The fillets were smoothed with finger then a Q-tip.
The 1 1/4" long x 1/8" diameter launch lug was covered with the orange skin square from the 24 lb. printed sheet.
Rub on a thin coat of glue stick and roll the skin around the lug.
Glue the lug at the base of a red/orange fin side.
No comments:
Post a Comment