From the back end of the A1 tube you can see the Bic pen barrel inside.
Because this is a hard plastic, the antenna holes will have to be drilled.
I used my small pin vise drill to make the antenna holes.
The antenna wires would bump into each other at the center of the A1 tube.
The wire on my work table shows the bend in the wires so both will fit around each other inside the A1 tube.
The center of one wire will be above, the other below.
Once the wires are place and sticking straight out of the tube, glue was applied with the tip of a toothpick.
No comments:
Post a Comment