Monday, February 15, 2016
Thor Able Carded Build Part 4 Internal Rings
The Support Strips were already glued inside the B3 Lower Body.
The rings you made will sit against these rings.
TIP: I found I had to sand away a little of the edge to fit better against the B# Connector Tab.
The rings were pressed into the tubes until they rested against the support Rings.
Glue was applied with a toothpick tip once I was sure the rings were seated against the support rings.
In the picture, a Q-Tip was used to smooth out the glue and remove excess.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment