Thor Able Carded Build Part 5 End BP Plate

I had to cut a circle in the center of the BP end piece to fit the BT-5.
As before, the tube was centered and a line drawn around the end. Cut and sand round to fit the tube.





This is the notched BP connector ring in place.
It is slightly recessed down to the printed blue line so when the BP end piece will end up flush with the end of the main body.






As expected, I had to cut off the gimbal motor pods and make new ones that were lightly smaller.
These pods butt up against the engine bell. My engine bell will end up being the BT-5 tube.