Monday, April 4, 2016
Estes Hi-Flier XL, #3226 Build, Part 5, Making A Baffle
A good sharp scissors should be able to cut around the pencil line traced earlier.
Cut just outside the pencil circle. The excess will be sanded off even with the outside of the coupler later on.
Using the rotary punch, holes were made in the upper (left) and lower (right side) ring.
Look close and you can see smaller circles to center the hole punches.
Mark a center line on the upper ring and punch two small holes for the Kevlar tie loop.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment