Semroc Andromeda Chrome Wrap Fix, Tips, Part 2

Here's the original Estes instruction illustration showing the spacing of the chrome bands.

The low wrap is 1 1/2" above the centering ring joint. The second wrap goes 1/4" above that.

On the left, the first wrap is in place, using the top edge of a masking tape wrap for a reference line. Why use a tape wrap? Getting a sticky wrap to meet up at the start point never seems to happen on the first try. The tape wrap gives you a straight around the tube reference.

After the first chrome wrap is set, a 1/4" wide masking tape strip was set above the lower wrap.
The upper chrome wrap is set down above the tape strip.

Here's the final decal art using the widest black band decal from the first three draws.

This decal print is available as a PDF if you are a Patreon blog supporter.

Here's the overlay decals on top of the chrome trim.
This is the same technique I've used in the past to "print" over chrome.

The width of the vertical bar wrap worked and is even all the way around. Sometimes things work out, it just takes me a year and a half to fix it.