The four leg holders snap into the Slide Tabs on the extensions.
Slide towards the center until they snap into place.
In the left side picture - notice the friction fit bumps. Those will have to be trimmed later for the aluminum legs to tightly slide in.
A Ribbed Disk is slid on followed by a round Steel Disk.
In the right side picture - This assembly is slid into the top of the black Swivel Head.
Flipping everything over - this is the bottom of the launcher Base piece.
The second Steel Disk is slid over the bolt, followed by the second ribbed disk.
Screw on the largest Wing Nut. Tighten the nut, but don't overtighten.
No comments:
Post a Comment