Aerotech Mantis Launch Pad, Part 5, Assembly & Legs

Notice the "T" arm on the Launch Angle Control piece. 

It snaps into the the upward side Snap Locks on the Swing Arm Assembly.

There are two sets of Snap Locks, one on each side. If over time a Snap Lock were to break, you can turn around the Swing Arm Assembly and use the other side.

Notice how the bottom of the angled Blast Deflector slides into the tabs on the Swing Arm.

The Caution Sticker goes on the bottom face of the Deflector.

The white Support tube will raise the rocket above the blast deflector.

The End Caps slide into the outside open end of the four Legs.

The edges of the legs were a little rough.

I smoothed over the ends with a metal file and polished with some 220 grit sandpaper.