Enerjet by Aerotech, Arreauxbee-Hi, Part 6, More Fin Prep

I've done some prep work on this build, but it's not unusual for me. 

The key to a clean build is spending some time preparing kit supplied parts.

The three fins had molding seams on the outside edges.

The seams were sanded flat using 220 grit on a block, followed by 400 grit.

There were molding dot recessed on all three fins.

These were marked with pencil.

Some medium CA was dropped onto scrap cardstock. The glue was picked up on a toothpick and transferred into the dot recesses.

After drying the CA was sanded to surface with 400 grit on a block.