Estes USS Enterprise #1275, Part 50, The Last Decals!

Two red line decals are cut close to the ink so they will fit close to the raised seam joint.

These were brittle and one broke off at the end.

You may have noticed I haven't glued the primary hull disk to the secondary body assembly. I remember building this one in the 1970s. It was difficult to place the decals with the disk attached to the lower body assembly.

Here's the disk bottom with all decals in place.

And the top - 

These old decals will get some Future floor finish brushed on  with a Q-tip.

It's almost finished!!!