Micro-Maxx Estes Fat Boy, Part 8, Engine Mount & Streamer

The engine mount was slid in until the MMX motor was higher that the trailing edge tips of the fins. I didn't want the model standing on the engine mount tube.

After I was sure of the engine mount position, a glue fillet was applied using a Q-tip. 

The body is short so an upper glue fillet was also applied around the forward centering ring using another Q-tip.

The Kevlar line is tied to the elastic loop in the nose cone base. The loose end was pushed into one of the holes in the shoulder plug.

A plastic streamer was taped onto the Kevlar line one third the way down form the nose cone tie.