The die-cut hold down "tics" have to be cut through and extended to finish off the tip of the leading edges.
Start the blade cuts below the gap and continue straight up through the open tip.
Stacking the fins shows how much the die-cut blades were off.
Sand and even up the sides. Hold the four fins tightly, the cardstock is slippery!
The top of the die-cut is slightly rounded.
On the left - The back side shows raised pressure crushing.
On the right - The fin back side was sanded flat with 320 grit on a block.
To smooth the rough edges, the fins will require some filler/primer sprays and sanding.
No comments:
Post a Comment