Old MPC Launcher & Controller Part 3

Two flat head screws secure the gray top to the handle.
The inside looks very clean.

To the right (forward of the unit) are the two sides for the key contact.

The launch button sides had to be sanded a little so it wouldn't stick in the hole when depressed.

The two red handle sides are held together by one screw.
The top gray piece helps hold together the sides.

Under that square red piece the cord is wrapped for some strain relief.

From the bottom of the unit are five feet of wire with two larger clips for the battery connection.
The other two lines are twelve feet long and bare wire at the end.
At first I couldn't figure out why the cables were cut.
There was two micro clips on two 8" white wires.

All the cables are dry and stiff. That's understandable considering how long it's probably been in storage.