The pod tubes are glued onto the fins with the top of the tube even with the outside of the fin leading edge.
The nacelle was shot with filler/primer and sanded. After sanding the filler/primer you could still see some 3d print ridges. I applied some CWF, hoping it would stay in the grooves when sanding.
It did! On the left is the CWF applied. On the right is the CWF after sanding ready for the second coat of filler primer.
I did a tape wrap around the shoulder of the nacelle cones. The overhang was cut with scissors and folded out.
This was stuck down to scrap cardboard for the filler/primer spraying.
No comments:
Post a Comment