Monday, September 5, 2022

ASP Micro Sandia Sandhawk Build, Part 4, Engine Mount


The engine block is a little different on this one.
You have two 1 1/2" long couplers included in the kit.

To make the engine block, one coupler is cut in two making a 3/4" long block. It is easiest to use a single edge razor blade for this cut.

The Kevlar line is looped and tied around the coupler and tied.

Mark the second coupler at 3/4". This depth gauge allows a MMX motor to extend 1/4" out the back of the body. 

Thread the Kevlar line through the tube and out the top. Slide the 3/4" long coupler block into the tube end. 
Push the engine block into the tube up to the 3/4" pencil mark on the longer coupler.



The instructions say to use Super Glue (CA) to set the coupler/block.
I used a small drop of wood glue set in place with a Q-tip stick. 
 

No comments:

Post a Comment