The most difficult part of the build is sanding a 45 degree angle in the wing root edges. Use a sanding block for a consistent line.
This angled edge allows the wing root edges to fit over the top corner of the body tube.
Be sure to sand the angles in a "mirror" image.
I sanded my angles a bit wider than needed.
Notice the underside has a pencil line to show the gluing area against the flat sides of the body tube.
On the left is a Q-tip holder to allow all sides of the launch lug to be painted with CWF in one pass.
On the left is a Q-tip holder to allow all sides of the launch lug to be painted with CWF in one pass.
Be careful not to get CWF inside the open ends.
TIP: Start you brushing from the middle of the lug length and work the filler out to the ends.
On the wing bottoms -
I didn't brush any filled on the tube gluing area of the wing sides.
No comments:
Post a Comment