The first largest piece is set down behind the rear of the canopy.
Second piece (left side picture) runs down the sides of the canopy.
Third piece (right side picture) continues the tapering line forward.
These were very skinny and difficult to match the ends.
I used the gray nozzle wraps from the Odd'l kit decal sheet.
These wouldn't show up when set down on the dark blue paint.
I cut some white decal strips to go underneath the gray print decals.
The gray nozzle decals were rolled around the tubes over the white.
To cap it off,
A strip of scrap black print decal was set around the clear canopy.
No comments:
Post a Comment