This shows a decent end-joint of the upper detail ring pieces. A little bit of smoothed over glue on the joint and it shouldn't be noticeable.
The bottom trim ring pieces but up against the support housings. They were a bit wide and required trimming.
The launch lug was glued in place with medium super glue. A drop of CA glue was set on scrap cardboard. A toothpick was dipped in the drop of glue then the glue transferred into the root edge of a support housing.
The launch lug is small. You might find it easier to place by using tweezers to hold it while setting into the root edge glue.
Hi Chris!:
ReplyDeleteLooking good as usual! Too bad these are out of stock practically everywhere.
Sincerely,
J.W.