On the left is the kit face card picture.
On the right is a dry fit of one quarter panel. It ends up being spaced too high.
The three images had to be cut and individually placed.
The two panels with the American Flags fit fine without cutting them apart.
These squares had to be cut to fit around the low end of the raised rib below the silver antenna dish.
I made a small hole using my rotary punch, then cut down the sides making a "U". In the upper picture, the punched decal is actually held upside down.
Some of the decals are tiny.
TIP: Pick up the decals with tweezers. Dunk them, then float the decals on the surface of the water for soaking.
No comments:
Post a Comment