Friday, December 7, 2012

FlisKits Triple Threat Build Part 6 Fin Prep and Glue





I was careful to align the fin plates but there was a little bit of overhang to clean up.
A sanding block evened up the sides.







Some of the paper fin plates won't sand off. The edges will roll around and onto the balsa sides.
Look close and you'll see the white edges of the plates.
Trim them off with a blade.





I didn't find the kit's fin alignment guide so I used my printed standby guide.
This works well for the three-finned Persephone saucer but not for the five-finned Athena model.

No comments:

Post a Comment