Friday, October 23, 2015

Estes QCC Explorer Build Part 10, Fitting the Intake Contour

Wrap some 220 grit around the body tube to sand the bottom of the intakes to match the curve of the body tube.

The upper intake is before,
The lower intake is the fit against the BT-60 body tube after contour sanding.
Keep an eye on the back of the intake when sanding.
All the intakes should end up at the same height at the front and rear.

The picture shows a good fit of the intake rear. This fit won't require any more than a fillet of Titebond M&TG for a fillet.

No comments:

Post a Comment