I don't know what I was expecting, maybe a large tube like in the Flying Stovepipe plans. The body of the glider is rolled card stock.
(Don't stare at the printed circles too long - you'll be hypnotized!)
There is a thin yellow line to cut on with scissors.
I shaped the ring glider as always by using a dowel.
Set the card stock in the heel of your left hand. Press and slide the (clean) dowel over the card stock for a smooth round shape.
Curve the "arms" at the top until they touch.
On the left side a piece of Scotch tape is pressed.
Center and join to the right side.
Apply tape to both sides
The round glider body is slid into a slot running around the connecting ring.
The joint on the card stock body lines up with a molded line between the two molded lugs.
No comments:
Post a Comment