Quest/Enerjet Big Dog, #Q5010, Build Part 5, More Stickers

Here the rocket body is turned over.

I'm working out water drops under the surface.

You should try to work out the water as you are wrapping from the center name out. Set down the center of the sticker and work around the tube slowly, pressing out the water and any air as you go.

I used another piece of penciled masking tape for a centering guide for the "dots" vertical sticker and the horizontal "BD" sticker.

Both of these two stickers are centered between the two fins and on the opposite launch lug side.

TIP: Set the large body wrap to purposely overlap the top of the tube. The overlap is cut off using a new razor blade using a small sawing back and forth motion.

The white lip of the body tube is colored with a red Sharpie.

The "Paw Print" stickers go on the fins.

Like the Estes Big Daddy, there are only two stickers to be placed on facing one side.

These are big sharp graphics. I just wish there were another set to place on the opposite side.