Tuesday, March 31, 2015

TLP Pershing #K046 Build, Part 43, The Orange Bands - Part A



A strip of paper was wrapped and pressed into the tunnel joints to get a width estimate for the orange bands.

The orange bands were cut off the painted orange self adhesive label sheet.
The Estes kit band decals were 1" wide.
Everything in this slightly smaller (BT-100) Pershing was multiplied by .995 to get the smaller sizes. The band ended up being cut at an obvious .995" wide.

The band halves were carefully cut out.
Set them side by side to be sure they are the same size.

You'll want the both sides the same where they meet up around the other side of the tube.

No comments:

Post a Comment