I had already started making the small details (last picture below) and fins using parts I had on hand.
After I received my order from BMS, here's the remaining parts needed.
There are seven BT-5 tubes, six outer tank tubes cut to 6" long.
The central vent tube is cut to 6 1/2" long.
In total, there are six centering rings:
Two 55-60 rings, two 5-60 rings and two 20-60 rings for the engine mount.
On the upper end,
The PNC-55AC nose cone, A 4 1/2" length of BT-55, Two 55-60 rings, The printed adapter and A 2" length of BT-60.
These smaller details were made in the preceding blog posts.
Three ullage rockets,
Two turbine exhausts,
Four interstage rockets
Four antennas and antenna panels and
the longer conduit.
No comments:
Post a Comment