Saturday, October 1, 2022

Estes Space Shuttle Columbia Build #1385, Part 20, Trim Decal Flaking & Nose Cone Mask Fix


After trimming, the edge of the gray trim decal lifted a bit. Normally you can brush on a bit of Future and that will tack down the lift.
I dipped a Q-tip and rolled it over the edge knowing some would seep into the lifted area.


I lightly pressed down the edge and some of the gray paint chipped off leaving some white from the decal sheet.






Well, it was worth a try!
I ended up pulling up the gray trim decal leaving the entire bottom of the wing black. I won't be doing another full model mask on this one. It's a semi-scale model now with semi-scale paint.




There was a piece of clear tape that overlapped a mask line on the side of the nose cone.

A marked tape strip was set down. Black paint was sprayed in a cup and the touch up brushed over.







Here's the bottom showing some of the completed masks and touchups.
Perfect? No - This was a difficult multi-layered mask.

1 comment:

  1. Looks great, as all your builds. I'm working on A Centuri Skylab clone.

    ReplyDelete