Monday, April 24, 2023

Wolverine Phoenix AIM-54A, Fix!, Part 3, Tube Cuts




At the pencil lines - 
A straight piece of 110 lb. cardstock was wrapped around the tube and taped closed.

Tape was also added to the bottom edge to keep the cardstock guide still while cutting.
I started with a razor blade but switched over to my X-Acto knife with a new #11 blade.

The cardstock guide edge made the cut pretty easy to do.

As always, don't try to cut through a tube with a single pass. Ease up on the knife. It should take a few rotations of the tube to cut completely through.

TIP: Turn the tube under the blade. Keep the knife blade still. 





This was a pretty clean cut. 

With the upper tube removed, repeat the second cut at the line 4" above this lower cut.

No comments:

Post a Comment