These two Star stickers go on one side of the four fins.
The stickers are printed on clear plastic. Peel off the sticker, dip in water. Leave wet and set in place on the model. The wet adhesive allows lifting and re-positioning if needed.
This red bar/name sticker is set between two fins and runs down the body tube.
A problem: The pre-cut band is wider than the area between the two fins!
Cut new vertical lines close to the red lines to fit the space.
See the finished side view picture below -
This is a great looking rocket with clean graphics.
A patriotic 4F/NC model.
Here's the fin with the two sticker star placement.
And finally - The white nose cone to cap it off.
No comments:
Post a Comment