The top picture shows the mask for the Green fins. The green was shot and the tape pulled.
Two days later allowing the paint to dry, another mask and the Black fins were sprayed.
The inset picture shows the upper fins.
The remaining fin on the opposite side of the black fins remain white.
I cut a curved arc from marked Scotch tape.
The lower picture shows the top half of the arc lifted from the cut piece. This is the arc that will be used in the nose cone tip mask.
On the left is the mask, only the tip of the nose cone is open.
After the tape was pulled -
Not my best result, the tape curve was a little wide. A bit of Silver got under the tape. It required some light scraping which took off some of the Gray. I'll be touching this up with a brush and calling it done.
No comments:
Post a Comment