Wednesday, March 2, 2022

ASP Ram B Build, Part 12, Large Vinyl Trim



This is the vinyl trim template sheet.
Cut them out using a knife and straightedge.

You are given enough black vinyl that if a mistake is made you can cut out a replacement. 

Notice the Lower Back Section template.
Here's how the lower vinyl section piece fit between the fins. 
Even though I used thinner 3/32" balsa, there would be some gaps near the tops of the root edges if the 1/8" thick balsa were used. 

If I were to do it again I would cut the the recesses wider to touch the root edges. Trying to match the rounded leading edge would be tough. 



Check the fit of the template before cutting out the Upper Black pieces. You might have to make adjustments to the width.
 




Matched corners on one side - 


Might not meet on the other.
I couldn't use this piece and had to cut another one slightly wider.

No comments:

Post a Comment