Estes USS Enterprise #1275, Part 29, The Tail Caps

GOTHCA! The tail cap liners (slip-in shoulder base) won't fit into the tail caps!

The diameter of the liner is the same diameter of the tail cap. Notice the sides of the liner taper towards the right side.

The instructions say to "sand the liners until they fit 1/4" into the tail caps. I sanded using 220 grit.

The picture to the right show how much of the edge was sanded off that first shoulder.

 

After sanding, one tail cap liner slid in.

The second liner required a cut slit in the side. No amount of sanding the tapered shoulder would allow a slip fit.